Enduramaxx Filter Kit C – Rainwater Harvesting Kit – 800m2

Filter Kit C has been designed for roof sizes up to a maximum of 800 sq metres and comprises a two-stage rainwater filter unit, syphon overflow, and calmed inlet.

On entering the filter, water flows across the first cascade to remove the largest debris particles. Pre-filtered water then flows over the secondary sieve filter (mesh size 0,65mm) where the mesh structure diverts any remaining debris.

The clean, filtered water is then delivered into the tank via a calm inlet. This allows the water to enter the tank with minimal turbulence and without disturbing any sediment at the bottom of the tank.

Rainwater entering the tank via a calmed inlet also supplies oxygen to the water, thereby preventing anaerobic decomposition. 

Finally, the overflow syphon, which incorporates a skimming inlet, skims the upper surface water and removes any further debris, oils, or other floating contaminants, thereby increasing the quality of the stored water.

Features:

Designed for roof sizes up to a maximum of 800sq metres (per kit)
For installation in a pilot shaft or against the wall in frost-protected areas
Available pre-installed in the pilot shaft
A two-step cleaning system independent of flow rate ensures high filtering efficiency.
Filter cartridge location assists in the continuous removal of dirt.
Suitable for 110mm (4″) and 160mm (6″) down pipes
Filter unit weight: 16 kg
Syphon overflow with a skimming inlet
Syphon overflow pipe to fit a 130 mm hole in the storage tank wall
Calmed inlet to prevent incoming water from disturbing any sediment in the tank
The calmed inlet also ensures fresh water is supplied to the lower area of the tank, resulting in the complete and regular replenishment of stored water.